Make
Yamaha
Model
P120
Year
2004

Disassembly

  1. Turn upside down and unscrew:
    • Rear 9x metal bolts, standard-pitch
    • 2 are longer than the others but this doesn't seem to matter - LHS 4x metal bolts, wide-pitch - RHS 3x metal bolts, wide-pitch - Leave secured: Front 5x wood screws for the keyslip
  2. Turn back upwards:
    • slide away the (wooden) facia board containing the control panel
    • fasteners slide in keyhole brackets built in to the cheeks
    • make sure the internal legs are clear of the base board - tilt wooden facia board backwards leaving left and right cheeks in place
      • left cheek is attached to base via ground wire
  3. Key servicing
    • disconnect
    • keyboard (8-pin?) data cable from control panel - unscrew
    • 1x black wood screw for ground wire from power circuits to base
    • 1x black wood screw for right-hand cheek
    • 9x brass bolts for keyboard
    • 2x brass screws for keyboard - slide keyboard back and lift out - all keys have
    • a metal tongue tensioner
    • a greased front clip, rear clip and vertical post - white keys
    • locked in place with a plastic tongue on the underside of the keyboard - black keys
    • when the metal tongue is correctly in place they should spring back when pulled towards the player and released
  4. Keyboard servicing
    • underside of keyboard has two linked circuit boards
    • undo 9x (?) silver screws
    • tilt circuit boards up and unclip
    • orange silicon keypads
    • 1x 5 key keypad (lowest notes)
    • 6x 12 button (octave) keypads
    • 1x 11 keypad - when reassembling
    • keypads must be aligned laterally over the contacts
    • keypads must be aligned so the lip on the straight edge fits in to the plastic groove on the keyboard frame
    • circuit board leading edges go under the clips
  5. Control panel servicing
    • control panel should be placed upside down (otherwise the buttons fall out!)