Make
Yamaha
Model
P120
Year
2004

Disassembly

1. Turn upside down and unscrew:

  • Rear 9x metal bolts, standard-pitch
    • 2 are longer than the others but this doesn't seem to matter
  • LHS 4x metal bolts, wide-pitch
  • RHS 3x metal bolts, wide-pitch
  • Leave secured: Front 5x wood screws for the keyslip

2. Turn back upwards:

  • slide away the (wooden) facia board containing the control panel
    • fasteners slide in keyhole brackets built in to the cheeks
    • make sure the internal legs are clear of the base board
  • tilt wooden facia board backwards leaving left and right cheeks in place
    • left cheek is attached to base via ground wire

3. Key servicing

  • disconnect
    • keyboard (8-pin?) data cable from control panel
  • unscrew
    • 1x black wood screw for ground wire from power circuits to base
    • 1x black wood screw for right-hand cheek
    • 9x brass bolts for keyboard
    • 2x brass screws for keyboard
  • slide keyboard back and lift out
  • all keys have
    • a metal tongue tensioner
    • a greased front clip, rear clip and vertical post
  • white keys
    • locked in place with a plastic tongue on the underside of the keyboard
  • black keys
    • when the metal tongue is correctly in place they should spring back when pulled towards the player and released

4. Keyboard servicing

  • underside of keyboard has two linked circuit boards
  • undo 9x (?) silver screws
  • tilt circuit boards up and unclip
  • orange silicon keypads
    • 1x 5 key keypad (lowest notes)
    • 6x 12 button (octave) keypads
    • 1x 11 keypad
  • when reassembling
    • keypads must be aligned laterally over the contacts
    • keypads must be aligned so the lip on the straight edge fits in to the plastic groove on the keyboard frame
    • circuit board leading edges go under the clips

5. Control panel servicing

  • control panel should be placed upside down (otherwise the buttons fall out!)